Skip to main content

Posts

Showing posts from July, 2020

Chain conveyor troubleshoot guide

  Problem Identification & Corrective Action Sl No. Problem Potential Cause Solution 1 Chain rises off from sprocket 1.Excess chain slack. 2.Excess wear at the bases of sprocket teeth. 3.Excess chain extension. 4.Foreign material stuck to the bases of sprocket teeth. 5.Reverse rotation of conveyor 6.Uneven chain tightening of chain 1.Adjust the amount of slack equally at both sides. 2.Carryout hard facing of the sprockets 3.Replace the elongated chain parts. 4.Remove the foreign material from the bases of the teeth. 5.Avoid reverse rotation of the conveyor when chain tightened is uneven 2 Chain separates poorly from the sprocket. 1.Sprocket misalignment. 2.Excess chain slack. 3.Excess wear at the bases of sprocket teeth. 4.Uneven chain tightening of chain 1-Adjust alignment. 2-Adjust the amount of slack.

Basic things you must know about nut bolts & spanners

A Bolt is a mechanical device which has head on one end of a body and a thread on the other end designed for fastening of two parts. Bolt is inserted into holes in assembly parts, it is mated with a tapped nut. Tension is normally induced in the bolt to compress the assembly by rotating the nut. This may also be done by rotation of the bolt head. A Screw is a headed and threaded bolt used without a nut. It is inserted into an internally tapped hole and tension is induced by rotation of the screw head. A Stud is a fastener with no head but it has threads at both ends of the shank. It, like a screw, has one end those screws into a tapped hole. A nut is used on the other end to create tension. Major diameter – largest diameter of thread (D) Minor diameter – smallest diameter of thread Pitch – distance between adjacent threads.       Boiler calculations for Boiler operation engineer (BOE) exam TOP-6 BEST POWER PLANT O&M BOOKS Types of nut bolts & Washer
close